Service life of the guide belt

The guide belt is a pure natural rubber product, which has high elasticity at room temperature, a little plasticity, and a very good machine hardness. Pure natural rubber usually refers to the pure natural latex collected from rubber trees, which is made of solid matter by condensation and very dry production. Guide belt has quite good resistance to gas permeability and resistance to a variety of chemical and electrical insulation, some special synthetic rubber has outstanding oil resistance and temperature resistance, can protect fat oil, lubricating oil, hydraulic oil, fuel oil and solvent oil swelling.
The actuating effect of the spring of the guide belt can overcome the slight bias of the metal joint surface and the wear of the seal lip, and the guide belt continues to maintain the intended sealing function of the guide belt. When you listen to this name, you will be dumbfounded! Stumped a large number of domestic producers! What makes you even more dumbstruck is the material of the C-type sealing ring.
The guide belt can withstand high temperature and high pressure and radioactive substances and has the function of resilient recall modified metal material. Let you fool again! Most of our domestic seal production enterprises are based on the production of relatively low-end rubber seals (such as: ○ ring and skeleton oil seals, etc.), such seals are cheap, but the demand is very large. Secondly, some seals are manufactured by polyurethane molding or injection molding (such as: U-ring, Y-ring, J-ring, UN ring, YX ring, etc.).
In view of the physical temperament of pure natural rubber, the guide belt has high elasticity and slightly plasticity at room temperature, and the guide belt has very good machine hardness and small hysteresis slip. Moreover, the guide belt has low heat generation when it is repeatedly changed, so its flexural resistance is also very good, which is derived from good or bad rubber, so the electrical insulation effect is outstanding. Guide belt, its service life, plot non-use materials, and working conditions. Moreover, assuming that the rubber method is different, then in different working conditions, the depth of damage to the guide belt is not the same. In addition, the stable depth of the production of goods, and the degree of machine fit, etc., will have a certain impact. Therefore, it is necessary to carry out collective consideration in order to be reliable and proper.